GETTING TO KNO
W
YOU
R VEHICLE
66
(Continued)
3. Continue to press and hold the
HomeLink® button, while you press and
release (“cycle”) your hand-held trans
-
mitter every two seconds until HomeLink®
has successfully accepted the frequency
signal. The indicator light will flash slowly
and then rapidly when fully trained.
4. Watch for the HomeLink® indicator to
change flash rates. When it changes, it is
programmed. It may take up to
30 seconds or longer in rare cases. The
garage door may open and close while you
are programming.
5. Press and hold the programmed
HomeLink® button and observe the indi
-
cator light.
NOTE:
•
If the indicator light stays on constantly,
programming is complete and the
garage door/device should activate
when the HomeLink® button is
pressed.
•
To program the two remaining
HomeLink® buttons, repeat each step
for each remaining button. DO NOT
erase the channels.
If you unplugged the garage door opener/
device for programming, plug it back in at this
time.
Reprogramming A Single HomeLink® Button
(Canadian/Gate Operator)
To reprogram a channel that has been previ
-
ously trained, follow these steps:
1. Place the ignition in the ON/RUN position.
2. Press and hold the desired HomeLink®
button until the indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button, proceed with
“Canadian/Gate Operator Programming”
step 2 and follow all remaining steps.
Using HomeLink®
To operate, push and release the programmed
HomeLink® button. Activation will now occur
for the programmed device (i.e. garage door
opener, gate operator, security system, entry
door lock, home/office lighting, etc.). The
hand-held transmitter of the device may also
be used at any time.
Security
It is advised to erase all channels before you
sell or turn in your vehicle.
To do this, push and hold the two outside
buttons for 20 seconds until the orange indi
-
cator flashes. Note that all channels will be
erased. Individual channels cannot be erased.
The HomeLink® Universal Transceiver is
disabled when the Vehicle Security Alarm is
active.
NOTE:
The universal garage door opener only oper
-
ates when the engine is running for security
reasons associated with removable tops and
doors.
Troubleshooting Tips
If you are having trouble programming
HomeLink®, here are some of the most
common solutions:
Replace the battery in the garage door
opener hand-held transmitter.
Push the LEARN button on the garage door
opener to complete the training for a Rolling
Code.
Did you unplug the device for programming
and remember to plug it back in?
If you have any problems, or require assis
-
tance, please call toll-free 1-800-355-3515 or,
on the Internet at
for informa
-
tion or assistance.
WARNING!
Vehicle
exhaust
contains
carbon
monoxide, a dangerous gas. Do not run
your vehicle in the garage while program
-
ming the transceiver. Exhaust gas can
cause serious injury or death.
20_GU_OM_EN_USC_t.book Page 66
