Alfa Plam LUCA 12, Инструкция по эксплуатации и техническому обслуживанию

Страница: 21 / 28

18
Missing encoder
signal
down and then
press P2 for more
than 3 seconds
Er08
Encoder error Flue gas engine is not
responding
Wait for the
furnace to shut
down
and then
press P2 for more
than 3 seconds
Contact the service center
Flue gas engine
operates at a speed that is
different from the set
speed
Er011
Clock error Problems with the
internal clock
Press and hold
P2 for more than 3
seconds
Check the accuracy of the
preset time
Insufficient capacity of
the internal battery
Check the correctness of
programming in the Chrono
mode
Contact the service center
Er012
Ignition failed Ignition error
Wait
for the
furnace to shut
down
and then
press P2 for more
than 3 seconds
Check the state and
quality of the used pellets During the ignition
phase adequate temp. of
flue gases is not reached
Check contamination and
draft of the flue drain
Faulty flue gas probe
Contact the service center
Er15
Interruption
of
power supply
Loss of power supply
during furnace operation
Press and hold
P2 for more than 3
seconds
Check to see if the system
and installation are in order
Contact the service center
Er16 Communication
error between the
electronics and the
display
Interruption of the
display cable
Press and hold
P2 for more than 3
seconds
Check the cable and
display cable connectors
Damage to the display
cable connector
Contact the service center
Er17
Primary air flux
meter error
Primary air flux meter
does not adjust the
operation of the furnace
The furnace
continues to run
without adjustment
of primary air.
Turn the furnace
off to reactivate the
air flux meter. Wait
for the furnace to
shut down and then
press P2 for more
than 3 seconds
Check pipe contamination
for primary air inlet
Check contamination and
draft of the flue drain and
funnel
Contact the service center
Er39 Primary air flux
meter sensor is
damaged
Faulty sensor The furnace
continues to run
without adjustment
of primary air
Contact the service center
Er41
The
minimum
primary air flux is not
reached during the
testing stage
There is an obstacle or
large contamination in the
pipe for primary air inlet
Wait
for the
furnace to shut
down
and then
press P2 for more
than 3 seconds
Check and clean the pipe
for primary air inlet
Check contamination and
draft of the flue drain and
funnel
Obstruction of flue gas
drain
Doors not properly
closed during the ignition
phase
Check if the doors close
well
Contact the service center
Er42
Primary air flux is
greater than the
maximum permissible
value
Too much air intake
Wait
for the
furnace to shut
down
and then
press P2 for more
than 3 seconds
Check the pipe for primary
air inlet
Check contamination and
draft of the flue drain and
funnel
Contact the service center
Description Possible solution of causes