Alfa Plam LUCA 12, Инструкция по эксплуатации и техническому обслуживанию

Страница: 13 / 28

10
The necessary checks and controls for the first ignition
The following guidelines must be followed when first igniting the product:
•
Make sure all safety requirements have been met (see section 1.8);
•
Connect the appliance to the power supply only when you are sure that the voltage power supply is 230 V 50 Hz.
When you’ve made sure of this turn the switch on the back panel to "ON” - switched on;
•
Make sure that the display on the control panel is turned on, which indicates that the appliance is properly plugged
into the power supply;
•
Make sure there is enough fuel in the tank for the planned period of operation.
The fuel must be in accordance with the instructions given in the relevant section of this guide.
Painted parts of the furnace can emit smelly fumes during the first few ignitions. This phenomenon is associated with
a chemical process of stabilization of used paint. For this reason, during this period the room where the furnace is located
must be regularly and properly ventilated.
Loading the fuel
Open the upper door of the product to insert the pellets. You must comply with regulations with regard to the fuel
contained in the relevant part of this user guide.
⚠
ATTENTION: Do not let the bag with wooden pellets come into contact with hot parts of the product while you load the
fuel.
⚠
ATTENTION: Do not remove the protective grid inside the part for loading the pellets.
⚠
ATTENTION: Do not lean the full weight of the bag containing the fuel to the product.
⚠
ATTENTION: Close the upper door when you have finished loading the pellets.
Periodically check the amount of wood pellets contained in the tank and fill it up in time.
⚠
ATTENTION: Excessive moisture can crush the pellets into fine powder, which can lead to increased sedimentation in
the boiler area, and even block the insertion/loading system (auger).
When inserting the pellets make sure that the pellets do not accidentally fall into the other inner parts of the appliance
except into the appropriate tank.
Only use pellets with a diameter of 6 to 8 mm.
Figure 3.1. Inserting the pellets
Control System of the Furnace
The furnace has an installed advanced control system which provides a safe, efficient and reliable controlling of the
operation and a maximum functional use of the furnace.
It is characterized by:

ease of setting up and using

easy and direct user features,

reliable and flexible functional software specifically designed for pellet furnaces,

advanced features available for installers in order to adapt different configurations and installations
Electrical connection scheme