Alfa Plam LUCA 12, Инструкция по эксплуатации и техническому обслуживанию

Страница: 15 / 28

12
P2 Turning on and off (hold down for 3 seconds), reset errors (hold down for 3 seconds), chrono activation
and deactivation
P3 Enter the user menu 1/submenu, enter the user menu 2 (hold down for 3 seconds), saving data
P4 Enter the visualization menu, maximizing
P5 Enter the visualization menu, minimizing
Led Feature Led Feature
Lack of pellets Preset room temperature reached
The direction of air flow Remote thermostat temperature
reached (if connected to the remote
thermostat)
Alarms
Description System state Code
Safety error - safety thermostat: signals when the system is off Block Er01
Safety error - pressure switch: signals only if the combustion fan is turned
on
Block Er02
Shutdown in case of flue gas temperatures lower than permissible Block Er03
Shutdown in case of flue gas temperatures exceeding the permissible
temperatures
Block Er05
The pellet thermostat is activated Block Er06
Encoder fan error: no encoder signal Block Er07
Encoder fan error: failed combustion fan regulation Block Er08
Date and time are not correct due to a prolonged power outage Block Er011
Ignition failed Block Er012
Power outage Block Er15
Communication error - display disconnected Block Er16
Air flux regulator error Block Er17
No more pellets Block Er18
Faulty air flux sensor Block Er39
The minimum air flux is not reached during the testing phase Block Er41
Maximum airflow reached (F40) Block Er42
Error: door open Block Er44
Auger encoder error: no encoder signal Block Er47
Auger encoder error: auger speed control failed Block Er48
Module error I/O 12C Block Er52
Service error. This informs that the planned period of operation has been
reached (after preload): the system will stop when it goes into operation mode.
Block Service
Other messages
Description Code
Probe error when controlling during the testing phase Prob
This informs that the planned period of operation has been reached. It is necessary to clean the
furnace or boiler.
Clean
Door open Door
The message appears if the system is turned off during ignition (after preload) by the external
device: the system will stop when it goes into operation mode.
Block ignition
No communication between the motherboard and the display (keypad). Link Error
Periodic cleaning is in progress. Cleaning On
Visualizations
Pressing P4 and P5 opens the visualization menu.
Here you can see the value of the ambient temperature, flue gases, engine speed of flue gases, ON auger time*, etc, at all
times. The following indicators of the furnace operation can be checked in the visualization menu:
Display Description
Exhaust T. [ºC] 103 Flue gas temperature
Room T. [ºC] 25 Local room temperature
Rem. Room T. [ºC] 25 Remote room temperature; visible only if the remote thermostat is active
Air Flux
750
Air flux; visible if the primary air flux gauge is active
Fan Speed [rpm] 1250 The exhaust gas fan speed;
Auger [ºC] 1.2 ON auger time;
Cleaning [h] 450 Work time left before cleaning the furnace; visible only if the timer is active
Work time [h] 2985 Total furnace work time in the work mode, modulations and security
Ignitions [h] 106 Number of ignition attempts
Product Code: 494- 0000 Product code