14/21
ALFA IN a.s
©
www.alfain.eu
3
8
5379
Tip long life 1.6 LT-150
2
8
5380
Tip long life 1.8 LT-150
2
13
5388
Contact nozzle retaining cup LT-150
1
14
5390
Spring Holder protection Nut LT-150
1
15
5391
Spacer spring LT-150
1
9
5382
Extended Diffusor LT-150
1
10
5383
Extended Electrode LT-150
1
12
5385
Contact Extended 1.35 - 90A LT-150
1
12
5386
Contact Extended 1.6 - 120A LT-150
1
12
5385
Contact Extended 1.35 - 90A LT-150
1
20
5396
Spacer for contact cutting Hand LT-150
2
22
5398
Locking Nut LT-150
1
7.
GETTING STARTED
7.1 FIRST STEPS
NOTE
This equipment must only be used by qualified personnel.
1. Before beginning work is necessary to connect the machine to the mains.
2. Check completeness of the mounted cutting torch.
3. See the picture below. Connect the torch to the connector. By means of the
thorn (part of the delivery) press the safety pin. Turn the nut of the
connecter clock wise and tight it properly.
4. Connect the compressed air on connector
A14
on the rear wall of the
machine.
5. Connect the mains plug to the mains socket.
6. After turning on the ON/OFF switch
A15
the display
A4
will illuminate.
7. Keep the switch
A1
pressed in the position
and set the air pressure
by means of regulator
A13
and manometer
A12
to 6 bars.
8. Connect the work lead cable to the material being cut and to the
connector
A11
.
9. Check up the input air pressure (min 5 bar, max 8,5 bar) and make a
