Alert 650R, Руководство по установке

Страница: 26 / 43

. .
26
PROGRAMMING
2 . Press the valet/program switch 4 times then hold it in on the 4th
press until two chirps with 1 long chirp is heard, then release the
valet/program switch . You are now in the Alarm feature #2
programming mode .
3 . Press and release the transmitters and buttons at the same time
twice, [2] LED flashes , [2] chirps to indicate the system is in the feature
“Password Pin Code Programming mode”
4 . Within 5 seconds, begin to enter your chosen first 9 digits by pressing and
releasing the valet/program switch from 1 – 9 times.
5 . Within 15 seconds of the last entered 9ths digit, turn the Ignition switch
to “ON” position.
6 . Within 15 seconds, enter your chosen second 9ths digit by pressing and
releasing the valet/program switch from 1 – 9 times.
7 . Finish by turning the ignition switch to the “OFF” position. If the new
password code was accepted, the unit will respond back with the newly
entered code, by flashing the LED, indicating the first digit code has been
memorized, pause and then the second digit code. The unit will repeat the
new code three times with a one-second pause between each code. Note:
If 15 seconds of inactivity expires, or if the ignition switch is turned “ON”
for more then 5 seconds during the above steps, the unit will revert back
to the last successfully stored code. [3] long chirps will confirm you have
exited the program. The unit will revert back to the last successfully stored
code.
Delete Password Pin Code / Override Without a Password Pin Code
(Factory default setting):
1. Turn the Ignition 'switch “ON” and “OFF” 3 times and then to the “OFF”
position.
2. Press the valet/program switch 4 times and then hold in on the 4th
press until two chirps with 1 long chirp is heard, then release the
valet/program switch . You are now in the ALARM FEATURE #2
PROGRAMMING MODE .
3 . Within 15 seconds, press and hold the transmitters and buttons
at the same time for 3 seconds. 1 long chirp will confirm the Password
Pin Code is deleted.
Exit: Press any button (except the button ) of the transmitter to exit the
password pin set up mode.
ALARM FEATURE # 3 PRORAMMING:
1 Turn the Ignition switch “ON” and “OFF” 3 times, then to the “OFF”
position.