Alert 650R, Руководство по установке

Страница: 20 / 43

. .
20
WIRING CONNECTIONS
Factory Security Disarm Signal Output – Factory Default
This wire is designed to disarm a factory installed security system. This
wire sends a (-) negative 1 seconds pulse upon a remote start and
remote door unlocking. Some factory systems must be disarmed to allow
remote starting. In most cases, this wire may be connected directly to
the factory alarm disarm wire. The correct wire will show negative ground
when the key is used to unlock the doors or trunk. This wire is usually
found in the kick panel area in the wiring harness coming into the car
body from the door.
Start Status (Shock Sensor By-Pass Control) Output–
This wire is designed to by-pass a shock sensor module. This wire will
supply an output at all times the remote start is operating plus an
additional 3 seconds after the remote start unit is turned off.
H8/9 ORANGE/WHITE Wire (Ground Output When Disarmed)
The ORANGE/WHITE wire provides a 200mA (-) negative output when
the security system is disarmed. This output can be used for activating
optional devises such as memory positions for power seats. Note: If not
attaching the ORANGE/WHITE wire directly to the BCM (Body
control module) a relay must be used to power the device being
energized.