Alert 650R, Руководство по установке

Страница: 38 / 43

. .
38
LED
Flashes Shutdown Mode
9 The procedure of the Check Operation Manual
Engine start memorizing Remote Start Operation Section.
for the vehicle with manaul
transmission gear is not completed.
TESTING YOUR INSTALLATION TECHNIQUES:
Caution!! The follow procedure must be performed after the installation of the
remote starter device. It is the responsibility of the installing technician to
complete these tests. Failure to test the unit in the following manner may result
in personal injury, property damage, or both.
1. Test the brake shutdown circuit: With the vehicle in park (P), start the
vehicle using the remote transmitter. Once the engine is running, press the
brake pedal. The vehicle should shut down immediately. If the vehicle con
tinues to run, check the brake circuit BROWN/RED wire (H5/2) connection.
2. Test the hood safety shutdown circuit: Start the vehicle using the remote
transmitter. Once the engine is running, pull the hood release and raise
the hood. The vehicle should shut down immediately. If the vehicle
continues to run, check the hood pin GREY wire (H5/1) connection.
1. Set the vehicle parking brake.
2. Block the drive wheels to prevent vehicle movement.
3. Sitting in the vehicle, turn the ignition switch to on or run position, but
do not start the engine.
4. Step on the brake pedal and shift the gear selector into “DRIVE” (D).
5. Put your foot over the brake pedal but do not press down on it. Be ready
to step on the brake to shut down the remote starter device.
6. Start the vehicle using the remote transmitter.
a. If the starter does not engage, the test is complete.
b. If the starter engages, immediately step on the brake pedal to shut down
the system and check your VIOLET wire H1/1 starter output connection.
The heavy gauge VIOLET wire must be connected to the ignition switch
side of the neutral safety switch. If the vehicle you are working on does
not have an Electrical Neutral Safety Switch, it will be necessary to
reconfigure the remote starts wiring to accommodate this vehicle. The
information concerning the mechanical neutral safety switch provided
below will help you to determine if the vehicle you are working on has
SHUTDOWN DIAGNISTICS
NEUTRAL START SAFETY TEST