Alert 650R, Руководство по установке

Страница: 32 / 43

. .
32
PROGRAMMING
Exit: Press the button on the transmitter. 3 long chirps and 3 parking
light flashes will confirm the program is exited.
IMPORTANT NOTE: You must program the “Tach Signal” before
trying to remote start.
ENGINE CHECKING TACH. / RPM LEARNING
1. Turn the Ignition switch “ON” and “OFF” 3 times and leave it in the
“OFF” position.
2. Press the valet/program switch 10 times and then hold in on the
10
th
press until 5 chirps with 1 long chirp is heard, then release the
valet/program switch .
3. Press and release the transmitters and buttons at the same time
twice [2] LED flash , [2] chirps to confirm the system is in feature
“RPM Learning mode” .
START FEATURE CHART #2
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
7 + The Vehicle The Vehicle has The Vehicle has Built-in Turbo
without Turbo aftermarket Turbo aftermarket Timer Control is
(The system timer installed. Turbo timer in- Active: Press
cannot be The system stalled: The + buttons at
Arm with the can be Arm with system can be the same time to
engine is engine running Arm with the set engine
running. and the shock engine running running for one
sensor will be by- and the shock minute.
pass as long as sensor will be
the engine is bypass for three
running. minutes.
Five chirps =Built-in Turbo Timer Control is active. Press +
buttons at the same time to control engine running 3 minutes.
Six chirps =Built-in Turbo Timer Control is active. Press +
buttons at the same time to control engine running five min.
8 + “Test” Mode for “Test” Mode for
Zone 2 / Instant Zone 1 & Zone
Trigger & Zone 4 (2 Stage Shock
3 / Door Trigger Sensor)