Alert 650R, Руководство по установке

Страница: 34 / 43

. .
34
PROGRAMMING
START TIMER PROGRAMMING: (TEST and ADJUST)
1. Press the button twice on the transmitter to start the vehicle.
2. If the engine starts, Wait for 15 seconds:
a . If the engine is still running.
I. Press the button twice on the transmitter to stop the engine.
You have completed this programming successfully.
II . Press the button on the transmitter to exit the program mode.
There will be 3 long chirps and 3 parking light flashes for
confirmation.
b. If the engine shuts down after the vehicle has been started.
I . Press the button twice on the transmitter to stop the engine.
II . Press the button on the transmitter to set “ Check Level ” to
LOW position. [1] LED flash , and [1] chirp to confirm this setting.
III . Repeat the step1 – 2.
3 . If the crank time is too long, (Engine is running, while starter is still
cranking):
a. Press the button twice on the transmitter to stop the engine.
b. Press the button on the transmitter to set the proper “Start Timer” .
The 1 chirp and LED pause will confirm you have entered this
programming. (Decrease “Start Timer” is necessary.)
c . Repeat the step1 – 4.
4 . If the crank time is too short, (Engine cranks but does not start):
a. Press the button twice on the transmitter to stop.
b. Press the button on the transmitter to set proper “Start Timer”.
The 1 chirp and LED pause will confirm you have entered this
programming. (Increase “Start Timer” is necessary.)
c. Repeat the step1 – 4.
ENGINE CHECKING OIL SENSOR
1. Turn the Ignition switch “ON” and “OFF” 3 times and leave it in the
“OFF” position.
2. Press the valet/program switch 10 times and hold in on the 10
th
press until five chirps with 1 long chirp is heard, then release the
valet/program switch .
3 . Press the transmitters and buttons at the same time to set the
“Engine Checking Oil Sensor”. [3] / [4] LED flashes , [3] / [4]
chirps to confirm this setting.
Once you have completed step 3, you can adjust and test “Start Timer”
as follows: