Alcorn Mcbride A/V Binloop Uncompressed, Руководство пользователя

Страница: 83 / 123

Alcorn McBride A/V Binloop Uncompressed User’s Manual Page 73
Hardware Description
Controls and Indicators
The Binloop is normally controlled either internally using a configuration
loaded from our Binloop software, or remotely from an external control
system. However, the product does have several controls and status
indicators located on the front panel.
Unit Status LED’s
On the front of the Binloop are nine LED's corresponding to the status of
the unit. Below is a brief description of their meaning:
Power (Green) - Power is being applied to the unit.
Fault (Yellow) - The unit has detected a fault condition.
Lock (Red) - The unit is has detected an external sync source (video
by default) and is locked to it. This lock can also be from
SMPTE/GPS.
Gen (Red) - The unit is actively generating SMPTE timecode.
Ready (Red) - The unit is ready to accept commands. This LED
should almost always be on.
Run (Red) – This indicator is illuminated whenever the SMPTE output
is active.
Pause (Red) - This LED is illuminated during SMPTE generation
when the Pause button has been pressed and a Pause at the SMPTE
End or Loop Time is pending.
Stop (Red) - This is illuminated whenever the SMPTE
Generator/Reader is idling and ready to begin SMPTE generation or
external SMPTE synchronization.
Mute (Red) - This LED is illuminated when the Mute button on the unit
has been pressed. This indicates that the audio outputs of all
reproducers are muted.