Alcatel-Lucent OmniTouch 8128 SE, Руководство пользователя

Страница: 31 / 63

8AL90344ENAAed01 25
OmniTouch™ 8128 SE WLAN Handset
6. Calling
6.1 Incoming Call
The flashing LED, accompanied by a ring signal and/or a vibrating handset signals a
call. Ring signal and vibrator can be disabled, see
7.5.1 Sound and Alert Settings on
page 39. The calling party’s handset information or name is shown. The local
phonebook name is displayed if the calling party’s handset number is stored in the local
phonebook, else the calling name or calling number is shown.
NOTE: When a headset is connected to the handset, the headset button can be used
to answer the call.
Other answering keys and methods can also be set in the Settings menu. For example,
it is possible to set the answering behavior to any key (with exceptions). The answering
methods are; Automatically, Loudspeaking, and Quick answer.
When “Automatically” is enabled, all incoming calls are connected automatically. At
“Quick answer”, the call is connected by lifting the handset out of the charger. See
7.5.5
Answering on page 45.
6.1.1 Answer a Call
When the signal sounds, press , “Accept” on the left soft key, or press to answer
the call in loudspeaking mode. The name/number of the calling party is displayed, if
calling line information is available.
6.1.2 End a Call
A press on the End key or the right Soft key “End” ends the call. The duration of the
call is shown in the display.
6.2 Outgoing Call
6.2.1 Pre-Dial
Enter the number and press or the soft key “Call” to get the line. The number is
shown on the display while dialing. If needed, press “Clear” to erase the number. By
using the Navigation key, it is possible to step and add/delete a digit in a number.
An international number can be dialed from the handset by entering a + character
followed by the country code and local number. To enter the + character, long press the
0 key until the character is shown in the display.
NOTE: The + character cannot be entered and international numbers cannot de dialed
this way, if the 0 key has been configured as a hot key, see 7.4.2 Define Hot Keys
on page 38.
Some keys and buttons can be programmed with a number, as described in 7.4
Shortcuts on page 38.
Press the pre-programmed key/button to dial the number. The call is automatically
connected.