Alcatel-Lucent OmniSwitch 9000 Series, Руководство по началу работы, Страница: 9 / 44

May 2007 Installing the Hardware 5
Unpacking and Installing the Switch
Unpacking the Chassis
To protect your switch components from electrostatic
discharge (ESD) and physical damage, read all unpacking
recommendations and instructions carefully before beginning.
Recommendations
•
Unpack your OmniSwitch chassis as close as possible
to the location where it will be installed.
•
Network Interface (NI) modules are packaged in sepa-
rate boxes. In order to reduce significantly the expo-
sure to electrostatic discharge (ESD) and physical
damage,
do not unpack these boxes until the NI
modules are ready to be installed.
Instructions
1 Begin by carefully cutting the tape along the seam
marked “OPEN HERE FIRST”.
2 Lift the box’s top flaps. Remove the smaller boxes that
are enclosed and set them aside. These smaller boxes
contain the Ship Kit and the switch’s Chassis Manage-
ment Modules (CMMs).
3 Next, completely remove the white plastic handle
inserts from the sides of the box. Removing these handles
allows the overpack to be removed.
4 The overpack is the outer shell of the packaging. Lift
the overpack straight up until it slides free from the rest of
the packaging. This allows easy access to the chassis.
5 Carefully remove the protective plastic from the switch
chassis.
6
In order to reduce the weight of the chassis, it is
recommended that you remove all factory-installed power
supplies prior to lifting it from the packaging. Steps 7
through 12 below provide instructions for removing power
supplies.
Note. Steps 7 through 12 apply to power supplies that are
newly shipped in the switch chassis. They have no power
cords attached and the on/off switches are in the off (O)
position. For instructions on removing power supplies that
are currently operating in an existing switch, refer to the
OmniSwitch 9000 Series Hardware Users Guide .
7 Loosen the two captive screws, located at the top and
bottom of the power supply’s front panel. If necessary, use
a flat-blade screwdriver to loosen the screws. Be sure that
both captive screws are completely disengaged from the
threaded holes in the chassis before continuing.