8
Installing the Hardware
May 2007
Note.
Clearance is not required at the top and bottom of
the chassis.
Rack-Mounting
Refer to the important guidelines below before installing the
OmniSwitch chassis in a rack.
•
Rack-mounting the chassis requires three people—two
people to hold the chassis and position it in the rack and a
third person to secure the chassis to the rack by using the
attachment screws.
•
The chassis has two integral rack-mount flanges that
support standard 19” rack mount installations. Refer to
page 11
for information on optional rack-mounting hard-
ware.
•
Alcatel-Lucent does not provide rack-mount screws.
Use the screws supplied by the rack vendor.
•
To prevent a rack from becoming top heavy, it is recom-
mended that you install the switch at the bottom of the rack
whenever possible.
•
If you are installing the switch in a relay rack, be sure to
install and secure the rack per the rack manufacturer’s
specifications.
•
Refer to
page 7
for important chassis airflow recom-
mendations before installing.
To rack-mount the switch, follow the steps below:
1
Mark the holes on the rack where the chassis is to be
installed.
2
Using two people, lift and position the chassis until the
rack-mount flanges are flush with the rack post.
3
Align the holes in the flanges with the rack holes you
marked in step 1.
4
Once the holes are aligned, use a third person to insert
a screw through the
bottom hole on each flange
. Tighten
both screws until they are secure.
OmniS
wit
ch 9700
1
2
3
4
5
6
7
8
NI
NI
CMM
PWR
PS3
PS2
PS1
A
B
Содержание OmniSwitch 9000 Series
Страница 1: ...060210 10 Rev D June 2007 OmniSwitch 9000 Series Getting Started Guide...
Страница 43: ...May 2007 Using WebView 39...
Страница 44: ...40 Using WebView May 2007...
