Alcatel-Lucent OmniSwitch 9000 Series, Руководство по началу работы

Страница: 17 / 44

May 2007 Installing the Hardware 13
Important. Do not turn on the power supplies at this time.
9
Install all remaining power supplies by repeating steps
1 through 8 for each power supply.
Using the Grounding Wrist Strap and
Chassis Grounding Lug
As electrostatic discharge (ESD) can damage switch compo-
nents, such as the Network Interface (NI) and CMMs, you
must ground yourself properly before continuing with the
hardware installation. For this purpose, Alcatel-Lucent
provides a grounding wrist strap and a grounding lug located
near the bottom-right of the chassis.
To ground yourself properly, follow the steps below:
1 Fasten the provided grounding strap to your wrist.
2 Insert the wrist strap’s connector pin (located at the end
of the strap’s tether) into the grounding lug near the
bottom-right of the chassis, as shown:
.
Note: The grounding lug diagram on the left is a general
diagram only. It is intended to show the location of the
grounding lug. No NI modules or CMMs should be
installed in your chassis at this time.
Important. For the grounding wrist strap to be effective
in eliminating ESD, the power supplies must be installed
in the chassis and plugged into grounded electrical outlets
as described on
page 12 .
7x
9x
11x
13x
15x
1
7x
19x
21x
23x
2 -XNI-U2
OS9-XNI-U2
50/60Hz,
8.0/7.0/3.5 A
100/115/250V
OVER
TEMP
DC OK
AC
OK
50/60Hz,
8.0/7.0/3.5 A
100/115/250V
OVER
TEMP
DC OK
AC
OK
50/60Hz,
8.0/7.0/3.5 A
100/115/250V
P
ETHERNET
COS
OLE/MDM
ETHERNET
CONSOLE/MDM
USB
LINK
AC T
LINK
AC
T
LINK/A
CT
LINK/A
CT
2
1
LINK/A
CT
LINK/A
CT
OK1
OK2
1
2
OK1
OK2
1
2
OK1
OK2
1
2
LINK/A
CT
LINK/A
CT
LINK/A
CT
LINK/A
CT
Chassis
Grounding Lug