Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 318 / 2018

SNMP Commands
page 10-22 OmniSwitch 6250 CLI Reference Guide November 2009
snmp trap filter
Enables or disables SNMP trap filtering. Trap filtering is used to determine whether a trap or group of
traps will be sent from the switch to a specified SNMP station.
snmp trap filter {ip_address | ipv6_address} trap_id_list
no snmp trap filter {ip_address | ipv6_address} trap_id_list
Syntax Definitions
ip_address The IP address for the SNMP station for which trap filtering is being
enabled or disabled.
ipv6_address The IPv6 address for the SNMP station for which trap filtering is being
enabled or disabled.
trap_id_list Specifies the trap(s) for which filtering is being enabled or disabled.
Traps must be specified using the numeric trap ID. You can specify
more than one trap in the command line; separate each trap ID with a
space and no comma.
Defaults
By default, SNMP trap filtering is disabled.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
To enable trap filtering, use the syntax snmp trap filter ip_address trap_id_list .
•
To disable trap filtering, use the syntax no snmp trap filter ip_address trap_id_list .
•
When filtering is enabled, the specified trap(s) will not be sent to the SNMP station. When filtering is
disabled, the specified traps will be sent to the SNMP station.
•
To display a list of traps and their ID numbers, use the show snmp trap config command.
Examples
-> snmp trap filter 172.1.2.3 1
-> snmp trap filter 172.1.2.3 0 1 3 5
-> snmp trap filter 300::1 1 3 4
-> no snmp trap filter 172.1.2.3 1
-> no snmp trap filter 172.1.2.3 0 1 3 5
-> no snmp trap filter 300::1 1 3
Release History
Release 6.6.1; command was introduced.