Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 1666 / 2018

QoS Policy Commands
page 39-170 OmniSwitch CLI Reference Guide November 2009
show policy classify tos
Specifies a ToS value for a hypothetical packet to show how the QoS software in the switch will handle
the packet.
show policy classify {l2 | l3 | multicast} [applied] tos tos_value
Syntax Definitions
l2 Uses the Layer 2 classifier for the hypothetical packet.
l3 Uses the Layer 3 classifier for the hypothetical packet.
multicast Uses the multicast IGMP classifier for the hypothetical packet.
applied Indicates that only applied policies should be examined.
tos_value The Type of Service bits value included in the IP header. The three most
significant bits of the byte determine the precedence (i.e, priority) of the
frame (0 is the lowest, 7 is the highest).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the
applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate policies.
•
If a ToS value is specified, a DSCP value may not be specified.
Examples
-> show policy classify l3 tos 7
See the output example given on page 39-143 for more information about the potential screen display.
Release History
Release 6.6.1; command was introduced.