OmniAccess AP60/61: Installation Guide
14
Part 031643-00 Rev. 01
June 2005
7
The
Clear Table
button appears after an entry in the list appears.
To erase all the table entries, click
Clear Table
. (You cannot clear selected
entries.) If a number of APs are provisioned and you click
Clear Table
, only the
entries which come up afterwards can be provisioned.
If the entry does not show up in the AP list, check network connectivity. Go to
the AP console and verify if the AP has come up with the IP from the
provisioning subnet.
8
After the entry shows up on the page, configure the
location
,
Host
IP/Name,
Master IP address
.
If AP is going to be assigned a static IP, click
Use the following IP Address
and
enter the
IP address
,
Netmask
,
Gateway IP
.
If the AP is going to obtain an IP address using DHCP, click
Use IP Address
Using DHCP
.
9
After configuring the required parameters, select the entry from the list (AP
to which the configuration has to be applied) and click
Apply
.
The State field changes from
U
(
Unprovisioned
) to
In Progress
. to
P
(
Provisioned
).
N
OTE
—
Check that the configured parameters are reflected in the AP list entry.
N
OTE
—
Alcatel recommends that you provision each AP for a unique location as suggested by site-sur-
vey planning. Label each AP with this location information and place the AP in its proper location.
Failure to place APs in the location for which they were provisioned will reduce the effectiveness of
such RF features as triangulation.
10 Click
Back
to return to the previous page
We can see that the Subnet is still configured and Port/s are selected.
11 When finished provisioning APs, click
Disable
to disable AP Provisioning.
N
OTE
—
Disable AP Provisioning after all the required APs are provisioned. Ports that are enabled for
provisioning do not handle traffic. Therefore plugging an already provisioned AP into a port still set to
provisioning mode will prevent that AP from functioning.
Now the AP is configured with the Parameters given
12 Reboot the AP so the AP will come up with the new configured
parameters.
Use the Reprovisioning tab for APs which are already deployed but need to be
reconfigured. See the
AOS-W
User Guide
for information on reprovisioning.
Содержание OmniAccess AP60
