14
/ Swimming Pool Heat Pump Inverboost C
6.1.
Electrical protection
The power supply for the heat pump must come, preferably, from an exclusive circuit with regulatory
protection components (30mA differential protection) and a magneto-thermal switch.
• The electrical installation must be carried out by a specialized professional (electrician) in accordan-
ce with the standards and regulations in force in the country of installation.
• The heat pump circuit must be connected to a safety earth circuit at the terminal block.
• The cables must be properly installed to prevent interference.
• The pump is intended for connection to a general power supply with earth connection.
• Section of the cable; This section is indicative and should be checked and adapted according to the
needs and conditions of use.
• The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of installation.
6.2. Installation of the display deportee
Photo 02
Photo 03
Photo 04
6.3.
Connection to pilot the water pump
Photo 01
Photo 01
Photo 02
Photo 03
• The end with plug connects with the control panel (photo1)
• The other end of the signal wire. (photo2)
• Open the top cover of the heat pump, connect the end of signal wire through the cable ring.
(photo3)
• Insert the wiring into the designated position (code:COM 1 or COM-L) on the PC board. (photo4)
• Open the button upwards as (Photo 1 )
• Fix the dry contact wiring through the two holes as (Photo 2 & Photo 4)
• Press down the button and tighten the wiring as (Photo 3 )
Photo 04
