M o d e S e l e c t i o n s
This mode constantly tracks increasing or decreasing torque
variations. Use this mode to monitor varying torque on motors
and machinery. Also for calibration and testing of dial torque
products (small wrenches or dial screwdrivers).
Track
Track 1500 Hz
+00.000
lbf.in
Menu Tool Tests
The display retains the highest torque applied. Use this mode
during calibration or testing of any hand type torque wrench
(dial, beam, and screwdriver), as well as power tools.
Peak
Peak 1500 Hz
+ 25.010
lbf.in
Menu Tool Tests
The display holds the first detected torque peak applied. Before any
torque is applied, the display show dashes in the torque value area.
Once peak is detected, the display will show the torque value. If a
second peak is detected then it will be displayed in the lower right (in
small reverse video).
This function is primarily used for testing and calibrating click type
mechanical torque wrenches. The PTT captures the point where the
wrench clicks. This peak may be used for operator training on correct
use of the wrench. Always apply torque smoothly to avoid false first
peak readings.
See page 11 for setting up First Peak.
First Peak
FPK 3000 Hz
-------
lbf.in
Menu Tool Tests
FPK 3000 Hz
5.4373
lbf.in
Menu Tool Tests
+7.6261
This mode is used to determine “first movement” or what is commonly
known as “break-away” torque to determine the actual torque on the
joint. An angle enabled transducer is required to operate in this mode.
See page 9 for setting up Angle Threshold.
Audit
Audit 1500 Hz
10.510
lbf.in
Menu Tool Tests
This allows an operator to set up an initial torque and follow up with a
rotation to a specified angle and display the final torque.
The PTT can collect Torque and Angle data if the unit is connected to a
transducer that includes the angle function. It is a "Real Time" angle
function that can capture Torque and Angle up to 8000 RPM.
See page 10 for setting up Angle.
Angle
T+A
3000 Hz
9.9985
lbf.in 10 deg
Menu Tool Tests
Page 7
0.00
