Alarko OPTIMA, Инструкция по установке и эксплуатации

Страница: 15 / 48

15
Figure 5.3: Control Box Position Adjustment
6.2 Mechanical Installation
1. Make sure that all the piping of the system must be done before beginning
the installation.
2. Close the valves on the inlet and outlet side to isolate the pump from water
flow.
3. Check the coherence of the system pressure and the min. & max. pressure
values of the pump. See Section 5.2.
4. Mount the pump to the pipes while taking the arrow on the pump housing
into consideration. The water flow of the system and the arrow on the
housing must be in the same direction.
5. Place the gaskets of the pump onto the both sides. Make sure that the
gaskets do not prevent any water flow.
6. Use the washers, bolts and nuts given in the Table 6.1 to fix the pump to the
pipes.
The position of the control box can be changed in order to see and use the
display easier. To adjust the position, the 4 bolts, which hook the motor housing
and pump housing together, are removed and the motor housing is adjusted by
rotating it to the appropriate one from the allowed positions and reconnected to
the pump housing with bolts.
Do not separate the motor housing from pump housing.
Rotation process should be done carefully and slowly. Seal
damage causes leakage.