Commissioning
22 (48)
Installation manual Remotus Jupiter 10BD, Era 4/6/8B FSK16 Version: B0 Document-ID: 954045-000 EN Author: SH
7.2.8 Heavy weight PIN-code
The transmitter is equipped with a user configurable heavy weight PIN-lock to prevent unauthorized access
to heavy weight lift. The heavy weight PIN-code is disabled by default.
Enable Heavy weight PIN code:
1. Enter the configuration menu.
2. Then select “Heavy weight PIN code”;
with bottom right button
(browse with top buttons)
.
3. Enter PIN: Enter the four last numbers of the CIM ID.
4. Enter new PIN:
Enter the new 4-digit PIN (not same as the four last in CIM ID).
5. Repeat PIN: Repeat the PIN-code.
6. Automatic return to the main menu or restart the transmitter.
Delete
number
Select number
(Press B1
repeatedly)
Choose
number
Choose
number
Select number
(Press B1
repeatedly)
Delete
number
PIN-code (CIM ID):
Go to system info (see 7.2.9).
ID=XXXXX:YY Z/Z take the
four last numbers (X). This is
the PIN-code.
Disable Heavy weight PIN code:
1. Enter the configuration menu.
2. Then select “Heavy weight PIN code” with B8
(browse with B1 and B2).
3. Enter PIN: Enter the old PIN-code.
4. Enter new PIN: Enter the four last number of the CIM ID.
5. Repeat PIN:
Repeat the PIN-code (four last number of the CIM ID).
6. Automatic return to the main menu or restart the transmitter.
7.2.8.1 Enter and activate heavy weight PIN during operation
When heavy weight PIN is enabled the system will not lift heavy weight (over 5-ton) before the correct
heavy weight PIN code is entered.
1. Press and hold down the bottom left button (step 2) for more than 3 seconds. This will activate the
heavy weight PIN-code entry mode.
2. Enter the 4-digit heavy weight PIN-code by pressing top left button repeatedly to select number
and bottom right to choose the number. Delete a number with top right button.
3. After the four digits have been entered the transmitter returns to normal operation mode. If the cor-
rect 4-digit PIN code is entered, bottom left button LED will light and the remaining function for
bottom left button will continue to be active (heavy weight activated).
7.2.8.2 Deactivate heavy weight during operation
Press and hold down the bottom left button (step 2) for more than 3 seconds until bottom left button LED
goes out.
7.2.9 System info
Shows firmware version for the CIM card, ID number and transmission packet rate.
Press any of the two bottom buttons for exit this menu.