AJA io hd, Инструкция по установке и эксплуатации

Страница: 21 / 110

1
13
Io HD Installation and Operation Manual — Rear Panel
Settings menus (or Easy Setups ). While capturing, the selected inputs are mirrored at Io
HD’s outputs. When not in the capture mode, outputs change to reflect the output of
Final Cut Pro. In all cases, all Io HD’s outputs are active all the time. In other words,
the same output video appears simultaneously on the HDMI, SDI, composite, S-
video, and component outputs. (Note: S-video and composite are SD only formats, so
they will not output HD material.) This method of operation allows simultaneous
connection to VTRs and monitoring equipment.
About BNC
Connectors Although most video professionals are used to BNC connectors, you may not have
seen them if you’ve been using primarily desktop video equipment. BNC connectors
ensure a positive connection by the act of locking the connectors together via pins in
one connector that fit into slots in the corresponding connector.
To make a BNC connection, slide the cable connector over the connector on the Io
rear panel and then when seated, rotate the barrel of the cable connector 90˚ clockwise
until the connectors are locked together. When properly locked, the cable cannot
accidentally be pulled out.
Connectors Connectors on the rear panel are arranged in groups for easy installation and
maintenance. Connectors provided are:
•
LTC (2x BNC) for longitudinal timecode input and output.
•
SD-SDI and HD-SDI video with embedded audio, 2x BNCs for input and 2x
BNCs for output.
•
SD/HD Component YPbPr/RGB Video, 3x BNCs for input, and 3x BNCs for
output.
•
S-Video In/Out (Y/C), 1x 4-pin mini-DIN for input, and 1x 4-pin mini-DIN
for output.
•
Composite NTSC/PAL video, 1x BNC for input, and 1x BNC for output.
•
Genlock/Reference Video (looping), 2x BNCs.
•
HDMI video with embedded audio (8 channels), 1x connector for input and 1x
connector for output.
•
8 channel AES/EBU digital audio inputs via 4x BNCs and outputs via 4x BNCs.
Pins (2) on BNC Connector
Align slots in
cable connector
barrel with connector
pins, then slide it over the pins
and rotate the barrel
to lock the connectors
(connector on Io Rear Panel)
together