Aituo AM121 Series, Руководство пользователя

Страница: 23 / 28

Shenzhen Aituo Automation Device Co.,Ltd
23
Adjusted accessories and the methods
Based on the differences of the wire size
，
refer to the soldering effect
，
some parts need to
be adjusted as below
：
1
、
Press wire parts
：
Regarding to the differences of wire size
，
adjust and screw the nuts to
make sure the proper distance between the press wire parts and the plastic parts,so the press
wire will not be dropped.
2
、
Stripping parts
：
Adjust the top and bottom knives
，
to make sure fast and properly stripping
the inner wire skin but no harm to the copper wire.
3
、
Pulling parts
：
Adjust and make sure to straighten the press wire but not harm.
4
、
Grippers
：
Once the diameters of the wires are much different
，
it needs to replace the
proper grippers to make sure the perfect soldering effect.
Attention matters
1. Daily for each slipper and every grease fitting of the machine to add oil nozzle, to ensure
that the lubrication between moving parts, for the black parts, add rust-proof oil, maintain
its dry and clean.
2.Once there is a unusual noise when running, pls stop the machine timely and check the
machine to solve.
3. If discover there is nut loosing, screw parts should be repositioned and tighten, after
confirm the installation, use manual control to operate the single action, if there is no problem
then run the machine automatically.
4. If there are wires or connectors stuck in the machine, please get it out timely,avoid to
damage the machine.
5. Please disconnect the power supply of solder station or the machine when the machine is in
long-time standby, to prevent soldering iron head heating for a long time, resulting in
unnecessary oxidation, which will shorten the using life of the soldering iron head.