Aituo AM121 Series, Руководство пользователя

Страница: 21 / 28

Shenzhen Aituo Automation Device Co.,Ltd
21
8
、
Q:How to adjust when connector stuck at feeding pathway or push material parts?
A:Disconnect the air supplier and refer to follow solutions:(as follow picture)
1) These may caused by some of inner rubber diameter defects or quality defects.
1
The inner rubbers are stuck in feeding pathway, use fingers to touch the inner rubber return to
normal position and smooth sliding, if not, it need to sort out inner rubbers from this pathway.
2
The inner rubbers are stuck in push material parts,try to use the little stick to push the material
launch with the pathway,and then push out the material with push control road.If can not , loosen
the two screws in the cover plate, remove the cover plate and take inner rubber out, then close
cover plate and the fixed the nuts.
2
）
There is any other things on the feeding pathway or it is no coincidence of pathway
；