Airxcel AHE-125-DN1, Руководство по установке

Страница: 12 / 35

Fluid Expansion Bottle Fluid Expansion Bottle
©Aqua-Hot®
125DN Installation Manual REV 220419
©Aqua-Hot®
125DN Installation Manual REV 220419
p. 21 p. 20
Burner Harness
BURNER X6
BURNER X3
Burner Bottom View
Burner Wire Harness Diagram
Figure 39
Figure 40
7. Locate the Aqua-Hot wire harness plug (Part Number ELE-
102-210). The connectors for the Aqua-Hot harness and
the burner harness are shown below. Reference page 18
for more information.
8. Plug in the connector X212 to the burner X211. The
diagram below shows more detail.
Pin Number Description
1 Power-On Signal
2 Heater Status Signal
3 Ground
4 High Altitude Power
5 Constant Power 12V DC (25A Max)
9. Organize and tidy the wires that lead to the burner and the
Aqua-Hot to protect them from damage and short circuits.
Connecting the Burner to the Aqua-Hot
These instructions will cover the installation and connections
for the diesel burner to the 125DN.
Installation Instructions
1. Mock-up the locations for the diesel burner and the Aqua-
Hot within the RV to ensure that there is adequate room for
access of the burner and the Aqua-Hot.
2. Verify the Aqua-Hot is secured in place.
3. Position and secure the diesel burner in place.
4. Reference the image below for the burner for the supply and
return ports for the antifreeze and water heating solution.
5. Connect the diesel burner return and supply hoses to the
Aqua-Hot as indicated by the graphic below.
6. Secure the plumbing to the burner with constant tension
hose clamps.
Connecting to the Aqua-Hot
Figure 44
Figure 45
Figure 43
“To Heat Source”
“From Heat Source”
Figure 42
“From Heat Source”
“To Heat Source”
Figure 41
X211 Burner Connector
Burner Harness ELE-102-211
X212 Aqua-Hot Connector
Aqua-Hot Harness ELE-102-210