AirStage ASUB18RLAV, Руководство по установке

Страница: 11 / 17

En-10
(2) External output terminals
• When picking up output signals for operating status, abnormal conditions or indoor unit
status.
Wiring methods and speci fi cations
1
2
3
4
P.C.B
CN16
*4
+
+
-
-
-
-
DC power supply
12 - 24 V *2
Connected load
*3
Connected unit
Connected load
*3
Connected load
*3
*2 Provide a DC 12 to 24 V power supply. Select a power supply capacity with an ample
surplus for the connected load.
*3 The allowable current is 30 mA or less. Provide a load resistance such that the current
becomes 30 mA or less.
*4 Polarity is [+] for pin 1 and [-] for pins 2-4. Connect correctly.
Do not impress a voltage exceeding 24 V across pins 1-2, 1-3, and 1-4.
Operation behavior
Connector Output voltage Status
CN16
External output 1
Pins 1-2
0 V Stop
DC 12-24 V *2 Operation
External output 2
Pins 1-3
0 V Normal
DC 12-24 V *2 Error
External output 3
Pins 1-4
0 V Indoor unit fan stop
DC 12-24 V *2 Indoor unit fan operation
A twisted pair cable (22 AWG) should be used. Maximum length of cable is 492 ft. (150 m).
*
Use an external input and output cable with appropriate external dimension, depending
on the number of cables to be installed.
(3) Connection methods
• Wire modi fi cation
Remove insulation from wire attached to wire kit connector.
Remove insulation from
fi eld supplied cable. Use crimp type insulated butt connector to
join fi eld cable and wire kit wire.
Connect the wire with connecting wire with solder.
Important: Be sure to insulate the connection between the wires.
Option parts
External input /output wire
Insulated connection
Field supply
Input No Voltage
terminal (CN17)
Controller PCB
Input Voltage
terminal (CN6)
Output terminal
(CN16)
CN17
CN16
CN6
Connecting cables
Controller PCB
Cable tie
(Field supply)
7. FIELD SETTING
There are 3 methods for address setting by FIELD SETTING as follows.
Please set by either of the methods.
Each setting method is described in below (1) to (3).
(1) IU AD, REF AD SW settings ............. This section (7.1. Setting the address)
(2) Remote controller settings ............... Refer to the wired or wireless remote controller
manual for detailed setting information. (Set IU
AD, REF AD SW to 0)
(3) Automatic address settings ............. Refer to the outdoor unit manual for detailed
setting information. (Set IU AD, REF AD SW to 0)
]1
7.1. Setting the address
Manual address setting method
• The indoor unit address and the refrigerant circuit address can also be set up through
the wireless remote controller
CAUTION
Be sure to turn OFF the power before performing the fi eld setting.
• Please set it according to the following procedures when setting manually.
[Front panel remove and installation]
Intake grill remove.
(1) Open the intake grille.
(2) Pull down the knob.
(3) Lift the intake grille upward and until the beating at the top of the intake grille is
removed.
Mounting
shaft
Front panel
Bearing
Intake
grille
Knob
Intake
grille
9373370154-01_IM.indb 10 9373370154-01_IM.indb 10 3/14/2012 3:03:54 PM 3/14/2012 3:03:54 PM