_______________________________________________________
4800B Series
AP User’s Guide
Association Table Page
DOC-710-005310-A0
Settings
Handle Station Alerts as Severity Level
This setting determines the Severity Level at which Station Alerts are reported in the Event Log. This
setting also appears on the Event Handling Setup page. You can choose from four Severity Levels:
Fatal Severity Level (System, Protocol, Port)
Fatal-level events indicate an event which prevents operation of the port or device. Typically,
for operation to resume, the port or device must be reset. Fatal-level events appear in red in
the Event Log.
Alert Severity Level (System, Protocol, Port, External)
Alert-level messages indicate that action has to be taken to correct the condition, and appear in
magenta in the Event Log.
Warning Severity Level (System, Protocol, Port, External)
Warning-level messages indicate that an error or failure may have occurred, and appear in
blue in the Event Log.
Information Severity Level (System, Protocol, Port, External)
Information-level messages notify you of some sort of event, not of a fatal nature (i.e., the port
has been turned off, the rate setting has been changed, etc.), and appear in green in the Event
Log.
Maximum Number of bytes stored per Station Alert packet
This setting determines the maximum number of bytes the AP stores for each Station Alert packet when
packet tracing is enabled.
Maximum Number of Forwarding Table Entries
This setting determines the maximum number of devices that can appear in the Association Table.
Default Activity Timeout (seconds) Per Device Class
These settings determine the number of seconds the AP will continue to track an inactive device
depending on its class. A setting of zero tells the AP to track a device indefinitely, no matter how long
it is inactive. A setting of 300 equals five minutes; 1800 equals a half-hour; 28800 equals eight hours.
Action Buttons
This set of four action buttons control option settings:
Apply
After checking new display filter options, press APPLY to accept the new settings. The Association
Table page will change to reflect the new settings.
OK
After checking new display filter options, press OK to apply the new settings and return to the Setup
page.
Cancel
Click Cancel to return to the Setup page without applying any changes.
Restore Defaults
Click to change all settings back to the AP’s default settings.
