Airmux Airmux-200, Инструкция по установке и эксплуатации

Страница: 30 / 40

Chapter 2 Installation and Setup AirMux-200 Installation and Operation Manual
2-6 Installation and Setup
Installing AirMux-200 Management Software
AirMux-200 management application is distributed on CD-ROM as an executable
file. The application has the following PC requirements:
•
Memory: 128 MB RAM
•
Disk: 1 GB free hard disk space
•
Processor: Pentium 3 or higher
•
Network: 10/100BaseT NIC
• Graphics: Card and Monitor that supports 1024 × 768 screen resolution
with 16 bits
•
Operating system: Windows 2000/XP
•
Microsoft Explorer 5.01 or later.
To install the AirMux-200 management program:
1. Insert the CD-ROM into your CD-ROM drive.
2. The autorun feature will start to install the software automatically.
3. Follow the on screen instructions of the installation wizard to complete setup
of the AirMux-200 Management program in the desired location.
Any PC running the AirMux-200 management application can be used to
configure AirMux-200 units.
Connecting the Power
Before connecting any cable, the protective earth terminals of the AC/DC
adapter must be connected to the protective ground conductor of the mains
power cord. If you are using an extension cord (power cable) make sure it is
grounded as well.
Any interruption of the protective (grounding) conductor (inside or outside the
instrument) or disconnecting of the protective earth terminal can make this
unit dangerous. Intentional interruption is prohibited.
Power is supplied to AirMux-200 via an external AC/DC converter, which receives
power from 100–240 VAC source and converts it to -48 VDC.
To connect the power:
1. Connect the 2-pin plug of the AC/DC converter to the 2-pin DC power
connector on the IDU rear panel.
2. Connect the AC/DC converter 3-prong plug to the mains outlet.
The unit turns on automatically upon connection to the mains.
3. After approximately 20 seconds the ODU will start beeping. The beeps
continue until the ODUs are aligned and the link set up.
Warning