Airmux Airmux-200, Инструкция по установке и эксплуатации

Страница: 13 / 40

AirMux-200 Installation and Operation Manual Quick Start Guide
Installing AirMux-200 Units 3
Do not stand in front of a live outdoor unit.
3. Align the site A ODU in the direction of the site B ODU.
4. Connect power to the site B IDU.
After approximately 20 seconds the ODU beeper starts beeping, this is
normal.
5. Verify normal operation of the IDU by the LED indications on the front panel.
6. Make an azimuth sweep with the site B ODU of 180 degrees. So that the site A
ODU position is learnt by the site B ODU.
7. Turn the site B ODU slowly back towards the site A direction, listening to the
beep sequence until optimal alignment is achieved.
Beeper Sequence
=beeper on
=beeper off
Description
[approx. 1s]
Best Signal so far
Signal quality increased
No change in signal
Signal quality decreased
[approx. 2s] No air link
Three beeps and a pause is the best signal
Two beeps and a pause, signal quality increased
One beep and pause is no signal change
Any other signal detects no signal between ODUs.
8. Secure the site B ODU to the mast/wall.
9. At site A, adjust the ODU slowly whilst listening to the beeper sequence until the
best signal is attained.
10. Secure the site A ODU to the mast/wall.
11. Monitor the link quality for about 15 minutes to verify stability.
12. Connect the management station to one of the two IDUs in the link.
13. Double-click the AirMux Manager icon to start the application.
14. Click the Installation button to open the installation wizard and follow the
installation steps.
Warning
Note