Aircel ABP Series, Руководство по установке и эксплуатации

Страница: 32 / 52

ABP Series | Blower Purge Desiccant Air Dryer
32
SERVICE SCREEN
The service mode screen is a screen that can be used
by a qualified service technician to operate the unit
in a manner to troubleshoot each step to locate any
problems.
Main Menu: Navigate back to the Main Menu.
Running Screens: Navigate to the main Operation
screen.
Activate Service Mode: Sets the dryer operation to
Service Mode (shorter run time and the ability to skip
heat and cool mode for troubleshooting).
Deactivate Service Mode: Turns Service Mode off.
Master Reset: Resets all settings and user operation
times back to the original factory setting.
HMI GoTo Config: Allows the user to enter into the HMI
Configuration screen, where the configuration for the
HMI as well as the program of the HMI can be altered.
Heatless Mode On/Off: Toggle heatless mode on during
heater or blower faults.
ACTIVATING THE SERVICE ROUTINE FUNCTION
The Activate Service Mode is used to observe the entire system operation in a reduced amount of time while also providing
the ability to advance a different step in the process, if required.
To activate the service routine function, navigate to the Service Menu and press Activate Service Mode.
NOTE: The Service icon will be visible on screen, indicating service mode is active. Once the service function is activated,
the program will not advance without the operator or service technician manually stepping through the program using the
Service / Proceed button when prompted.
To deactivate the service function, navigate to the Service Menu and press Deactivate Service Mode.
Caution: Typically only used by Aircel authorized personnel or qualified personnel familiar with the equipment. Always
note which step is current before cycling through the steps, so the service routine can be halted at the step the service
routine began. Make certain the correct actions are observed in each step such as: drying, depressurizing, heating, cooling,
re-pressurizing, parallel mode, and vessel switching.
For Alarm Information: Refer to this system display screen shots and descriptions section and the owner’s manual.
AIRCEL PROGRAMMABLE CONTROLLER (APC)
Service Screen