5
CAUTION: Do not spill water on fan motor. Electrical components must be
kept dry.
ABOUT HUMIDITY
Where you set your desired humidity levels depends on your personal comfort
level, the outside temperature and the inside temperature.
NOTE
: Recent CDC tests show that the chances of flu transmission are greatly
reduced at levels of 43% humidity.
You may wish to purchase a hygrometer* to measure the humidity level in your
home. The following is a chart of recommended humidity settings.
NOTE:
We
recommend using AIRCARE
®
or Essick Air
®
Bacteriostat Treatment when you
refill the water reservoir to eliminate bacterial growth. Add bacteriostat according
to the instructions on the bottle.
Under no circumstances should you use Water Treatment products intended for
Rotobelt or Ultrasonic humidifiers.
When Outdoor
Temperature is:
°F
°
C
Recommended
Indoor Relative
Humidity (RH) is
-20
-10°
2°
10°
20°
30°
-30°
-24°
-18°
-12°
-6°
-1°
15 - 20%
20 - 25%
25 - 30%
30 - 35%
35 - 40%
40 - 45%
*Model 1990 digital hygrometer is available for purchase by calling 1-800-547-3888.
NOTE:
External hygrometer readings and humidistat readings may differ.
Humidity levels can vary significantly even in one room.
OPERATION
Plug cord into wall receptacle. Your humidifier is now ready for use. The humidifier should
be placed at least FOUR inches away from any walls and away from heat registers.
Unrestricted airflow into the unit will result in the best efficiency and performance.
NOTE:
This unit has an automatic humidistat located on the cord that senses the
humidity level around the immediate area of the humidifier. It turns the humidifier on when
the relative humidity in your home is below the humidistat setting and will turn the
humidifier off when the relative humidity reaches the humidistat setting.
TO TURN ON/OFF
For initial operation
, plug the unit
in (the display will show - -). Press
the speed button and hold for 5
seconds to turn the unit on or off.
FAN SPEED
The 3D6100 has a four speed
digital control panel.
1) Press the SPEED button to
adjust the fan speeds.
2) The speeds: High (F4) - Low
(F1) display on the digital panel.
PRESS AND HOLD
TO TURN UNIT ON
PUSH TO ADJUST
FAN SPEED
PRESS TO
INCREASE
HUMIDITY
DIGITAL DISPLAY
IMPORTANT: Water damage
may result if condensation
starts to form on windows or
walls. Humidity SET point
should be lowered until
condensation no longer forms.
We recommend room humidity
levels do not exceed 50%.
