©
A
ir
B
orne
W
ind
S
ports
P
ty.
L
td.
SECTION 4
Aircraft Operating Instructions Edge XT 912
NORMAL PROCEDURES
January 2014
Issue 2.4
Page 50
4.2.1
Unzip Wing Bag
Lay the wing down with the zip up and the nose facing approximately 120 degrees from the wind
direction. Unzip the bag but do not completely remove it from the wing. Undo centre 2 clips.
4.2.2
Assemble Control Frame
Remove control bar and down tube padding. Spread the control bar
down tubes out and insert the base bar onto the alloy knuckle. The
pip pin is then inserted from front to back. Ensure that the pip pin
end cap is secure. It should not be possible to remove the cap
without depressing the pip pin button. Check that all the rigging
wires are outside the control frame.
Figure 1 Section 4. Assemble Control Frame
4.2.3
Optional - Training Bars
If training bars are to be fitted to the control frame follow this procedure.
Attach the bottom clamp loosely to the control bar. Loosely attach the top clamp to the downtube using
the following sequence:
1. Bolt, head to the inside of the control frame.
2. Tube.
3. Nylon Washer.
4. Down Tube Clamp (both sides).
5. Wing Nut, turned until both sides of the down tube clamp contact. Ensure the training bars are held
securely.
6. Safety Pin.
The fitment of the left hand side training bar is illustrated, showing the correct attachment of the bar on
the inside of the control frame. The right hand side training bar is secured in the same way and is also on
the inside of the control frame.
Removal is the reverse of this procedure.
Figure 2 Section 4. LHS Training Bar Attachment