Air Techniques Accent B5100B, Инструкция по эксплуатации

Страница: 22 / 32

I N S T A L L A T I O N
22
14. At this point, Windows should report:
F Fo ou un nd d N Ne ew w H Ha arrd dw wa arre e:: B Bllu ue etto oo otth h P Pe erriip ph he erra all D De evviicce e,
F Fo ou un nd d N Ne ew w H Ha arrd dw wa arre e:: S Stta an nd da arrd d S Se erriia all o ovve err B Bllu ue etto oo otth h lliin nkk,
and finally
F
Fo ou un nd d N Ne ew w H Ha arrd dw wa arre e:: Y Yo ou urr n ne ew w h ha arrd dw wa arre e iiss iin nsstta alllle ed d a an nd d rre ea ad dyy
tto o u usse e.
These messages may be repeated a second time.
15. Depending on the speed of
your system, installation time
varies. Windows may not finish
installing the new hardware
before the yellow progress bar
reaches completion.
If the bar changes back to grey
and the light remains red, press
the
W Wiirre elle essss ssyysstte em m
button to
complete the setup.
16. When the setup is complete,
the progress bar should now
show the state of the Bluetooth
Control Module batteries and
the sensor should be armed
and ready for use.
O P E R A T I O N
Acquisition Procedure
When the TWAIN interface for the ACCENT sensor is open, the yellow
LED should flash. If it does not, you must verify that your ACCENT sys-
tem is powered on, has a sensor plugged in and no other software is try-
ing to communicate with the ACCENT system.
If the yellow LED still does not blink after checking all conditions, then
refer to the Troubleshooting section for help on resolving the problem.
When changing the image resolution, the ACCENT system is disabled
and then re-enabled immediately afterwards.
To save battery life, the Control Module powers down after 3 minutes of
inactivity. Therefore, it should be turned on when the X-ray is ready to be
taken. If you exceed the 3-minute period, simply push the Power button
of the Control Module to re-enable the ACCENT system.