Air Techniques A6350-15, Руководство по установке

Страница: 22 / 31

Air Techniques, Inc . Page 20
Equipment Setup
5.6 Installing the Scissor Arm
Mount the scissor arm onto the installed horizontal arm by performing the following procedure .
NOTE: Apply grease lightly to the scissor arm shaft as necessary.
1 . Insert the scissor arm shaft into the horizontal arm making sure not to pinch the attached cables .
2 . Install and tighten the M5x25 grub screw into the hexagon screw .
3 . Make sure the hexagon screw is also tightly screwed in .
4 . Tighten the set screw on the side of the head of the hexagon screw .
1 2
Wire
Harness
Scissor
Arm Shaft
Horizontal
Arm
1 2
Hexagon
Screw
Set
Screw
Grub
Screw
5 . Attach the scissor arm brake with two M5x15 screws with spring washer on the horizontal arm .
6 . Connect the ground cable to the PE conductor by using the truss head screw .
7 . Connect the cables of the scissor arm and the horizontal arm and screw on the cover
with the two M3x6 flat head screws .
8 . Place the horizontal arm cover on the horizontal arm .
Scissor
Arm Brake
Cable Connections
Horizontal
Arm Cover
CAUTION
Scissor arm can spring open causing injury.
• Do not cut strap securing the scissor arm until completion
of installation procedures . .
Washer
Ground cable
H001211B