Feniks STUDENT Instruction Manual, No.
033-02-100
edition
IA
, 2012, page
8
of
38
AIR-POL Sp. z o.o.
– 05-120 Legionowo, ul. Olszankowa 52, www.air-pol.com.pl
tel.: (+4822) 774 0711, (+4822) 784 1595, (+4822) 774 4832, fax (+4822) 784 9640, @: [email protected]
2.1.
DACRON Steering Lines (larger diameter lines).
Fot. 3
1.
Thread the steering line through the grommet
from under the toggle (from the part of the
toggle fitted with mounting flaps).
2.
Wrap the toggle from one side with the
steering line and thread it through the
grommet starting from the upper part of the
toggle.
3.
Wrap the other side of the toggle and thread it
through the grommet from below.
You have an
8
-shaped weave
Fot. 4
4.
Adjust the weaves so that the “telltale” marker
on the steering line is located against the edge
of the grommet in the lower part of the toggle.
5.
Tie a knot as close to the grommet as
possible. Leave some excess line, should
steering line adjustments be required.
6.
Repeat the procedure for the other steering
line.
7.
Check the length and symmetry of steering
lines.
2.2.
Microlines (Spectra, Vectran, HMA, etc.).
Fot. 5
1.
Make a loop on the steering line below the
“telltale” marker (1) by tying a knot.
The loop should be approximately 5 mm wider
than the steering toggle tape.
Fot. 6
2.
Thread the loop through the grommet from
under the toggle (from the part of the toggle
fitted with mounting flaps), then thread the
lower part of the toggle through the loop.
Finally, tighten the line on the toggle and
grommet.
3.
Leave some excess line, should steering line
adjustments be required.
4.
Repeat the procedure for the other steering
line.
5.
Check the length and symmetry of steering
lines.
1
1
