AIMS Power PICOGLF12W12V120AL, Руководство пользователя

Страница: 20 / 27

AIMS Power www.aimscorp.net
USING A GENERATOR FOR AC
BEFORE YOU USE A GENERATOR, MAKE SURE IT IS SIZED TO
HANDLE THE INVERTER.
To guarantee the best performance of the built in AC charger and
when the AC input is from a generator, the standby generator should be at least 150% higher
capacity than the inverter.
Operating with an under-rated generator or generator with unqualified wave form may cause
premature failure which is not covered under warranty. Example: If you are using a 2500 watt
inverter charger, your generator must be 3750 watts or larger. If you are using a 1250 watt inverter
charger, your generator must be 1875 watt or larger, and so on.
3- 4 .
AC Wiring
We recommend using 10 AWG wire to connect to the AC terminal block (2500 Watt model only).
When in AC mode the AC input power will supply both the loads and AC charger, a thicker wire gauge for
AC Input is required. Please consult a qualified electrician about the specific wire gauge required in terms of
wire material and inverter power.
The output voltage of this unit must never be connected in its input AC terminal, overload or damage
may result.
Always switch on the inverter before plugging in any appliance.
*We don't recommend connecting AC input to a GFCI circuit as it will cause the supplied GCFI to
pop intermittently and fail to supply power to the charger and bypass power through inverter.
WARNING
S
Do not loosen or touch the rear set screws on the terminal block.
Wiring
120V single phase Input: Hot line
+ Neutral Output: N
Hot line +
Ground
3-5. Grounding
Connect an 8 AWG or bigger copper wire between the grounding terminal on the inverter and the
earth grounding system or the vehicle chassis.
18