Aimco SPC-P21225Q, Инструкция по эксплуатации

Страница: 9 / 20

9
LED INDICATION
Status of the Tool Action to be Taken
LED lights RED, YELLOW and
GREEN together for one second.
A long beep for one second.
The motor is
switched on.
None required
LED lights RED for one second.
A long beep for one second.
The preset torque
is not reached
(NOK).
The application
should be reworked.
The screw has
been refastened
after already tight-
Double Hit (NOK).
The application
should be reworked.
LED lights GREEN.
The preset torque
is reached and the
tightening is OK.
None required
LED Blinks YELLOW five times.
Five short beeps. Battery power is
low.
Recharge battery or
replace with fully
charged battery.
LED lights YELLOW for five seconds.
A long beep for five second.
Battery power is
too low for tool
operation and tool
will not run.
Recharge battery or
replace with fully
charged battery.
LED lights BLUE.
The tool is set to
run in reverse
operation.
None required.
LED lights RED twice.
Tool temperature is
too hot. Warning to
protect tool from
damage.
Remove battery and
allow tool to cool.
LED lights RED three times.
The motor has a
failure. Send tool in for
service.
LED lights RED four times.
Internal connector
wire has failed. Send tool in for
service.