Aimco SPC-P21225Q, Инструкция по эксплуатации

Страница: 8 / 20

8
Steps for Torque Adjustment
NOTE:
Remove the battery pack
before adjusting the torque to avoid
injury.
1. Lift the torque adjustment cover.
Use the torque adjust tool and
insert it in to the quick change
holder and turn until the adjust
hole appears below the cover.
2. Use the torque adjust tool to
turn clockwise to increase
torque and turn counterclock-
wise to decrease torque.
6. Prior to using on an application,
it is advised to verify the output
torque of the tool as set. Check
the torque on an
Auditor™ Digi-
tal Tester (or comparable sys-
tem).
7. Delivered torque to the applica-
tion may vary due to the type of
joint the tool is tightening. Good
practice is to perform periodic
audits of the application.
Audi-
tor™ Torque Wrenches of
Rotary Transducers
are ideal-
ly suited to make these checks.
Forward/Reverse Rotation
Switch Operation
To prevent damage, do not press
Forward/Reverse button until the
tool comes to a complete stop.
Forward Rotation Operation
The tool is in forward operation if
the blue light is not on.
Reverse Rotation Operation
By long pressing on the F/R switch,
users are able to choose the mode
of Reverse operation, either auto-
matic or manual.
Mode 1: Automatic – Tool re-
turns to Forward operation
automatically after reverse
operation.
Mode 2: Manual – Tool needs to
be adjusted manually to return to
Forward operation after reverse
operation.
Adjust Hole
Cover
Decrease Torque
Press
Increase Torque