Aichi SV06CNL, Руководство по эксплуатации с информацией по обслуживанию

Страница: 33 / 40

Chapter 10 - Transporting Method
ff
Chapter 10
Transporting
NOTICE
• This information about transporting is
offered as a recommendation.
• Only the qualified persons shall use the
transport vehicle, crane, forklift, and the
machine.
• All persons on transportation must
comply with employer, work area, and
local and national safety regulations
regarding the use of these machinery.
• Each machinery must comply with all
applicable regulations, and must be
inspected and used in accordance with
their manufacturer's instructions.
Preparation before loading 11
When transporting the machine by a transport
vehicle, beware of the following.
(1) The transport vehicle must be loaded and
unloaded on a firm, level surface.
(2) The platform must be lowered fully, and
retract and lock the extension deck.
(3) Make sure the bolts and pins for holding
the guardrail are tight.
(4) Check the entire machine for loose bolts,
and unfastened locks.
Loading the machine 21
WARNING
• Do not travel the machine on a slope
that exceeds the machine gradeability.
The wheels of the machine could fall off,
if the transport vehicle or the loading
ramps incline excessively.
• Do not turn the steering of the machine
while it is on the ramps, because of the
possibility of a fall.
• Use a winch for loading/unloading, if
the ramp is too steep or slippery.
• When loading/unloading, be sure to
have a guide assist you so that the
wheels do not fall off the ramps and the
transport vehicle bed.
• Failure to avoid these fall hazards could
result in death or serious injury.
Step 1
Chock the wheels of the transport vehicle.
(fig. 10–1, A)
B
B
C
A
M0851A01
fi g. 10f1
Step 2
Attach the loading ramps at as small an
angle as possible.(fig. 10–1, C)
Step 3
Travel the machine forward at low speed
onto the ramps, and load the machine
onto the transport vehicle.
Step 4
Stop the machine and chock the wheels
of the machine.(fig. 10–1, B)
Step 5
Pass the chains or wire
ropes through all the
hoisting rings and tie
down the machine
on the vehicle bed
securely. (Refer to fig. 10–2)