Aichi SV06CNL, Руководство по эксплуатации с информацией по обслуживанию

Страница: 23 / 40

Chapter 6 - Pre-Start Check
1f
Chapter 6
Pre‑Start Check
WARNING
• Do not operate the machine before
pre-start checks described in this
manual.
• Perform the pre-start checks on a firm,
level surface. Begin the checks with the
platform lowered, and the extension
deck retracted.
• If the pre-start checks reveal any
abnormalities, immediately put an
“Out of Order” sign on the machine,
and stop using the machine. The use of
the machine not repaired can cause a
serious accident.
After repairs are completed, perform
the pre-start checks again from the
beginning.
• If there is damage, such as cracks, on
the welds of the platform guardrails,
or on the guardrail pipes, replace the
guardrails immediately.
• Damage and stains to the decals will
obstruct correct handling. Immediately
remove the stain, or replace the decals.
• Make sure to perform the checks with
no load on the platform.
NOTICE
While the machine is being moved, or
the platform is being raised or lowered,
the motion alarm buzzer produces a
warning sound for personnel to stand
away from the machine.
Visual check 11
Step 1
Circle the machine once and check
visually that there are no oil leaks, and no
damage to the decals or to the machine.
Step 2
Make sure there is no damage, looseness,
or missing parts in the wiring, bolts, each
switch and the guardrail. Make sure all the
guardrails are attached properly, and all
the bolts, etc. are tightly fastened.
Step 3
Make sure all decals are in place, legible
and no damage. Replace any lost or
damaged decals. Use mild soap and
water to clean decals. Refer to section 2 of
chapter 2 for decals and their locations.
Step 4
Check the hydraulic oil level when the
platform is fully lowered and the extension
deck is retracted. Refer to section 2–1 of
chapter 7 for details.
Step 5
Check for battery leaks, and check that
there is sufficient battery solution.
Refer to section 2–2 of chapter 7 for
details.
Function check 21
Preparations for function 221
check
Step 6
Put the machine in the following state
– Put the machine on a firm, level surface.
– Lower and retract the platform fully.
– Operate the machine from the lower
control.
– Unload the platform.