Aichi SV06CNL, Руководство по эксплуатации с информацией по обслуживанию

Страница: 25 / 40

Chapter 6 - Pre-Start Check
1f
(7) Make sure the pothole protectors are not
fully come down when it comes in contact
with the piece of wood.
(8) Attempt to raise the platform. Make sure
the raise function is disabled.
(9) Turn the key switch to "UPPER CONTROL."
(10) Attempt to travel using the upper control
panel. Make sure the travel function is
disabled.
(11) Lower the platform fully.
(12) Return the upper control panel to its
original position and remove the piece of
wood which was placed in (5).
Upper control check 226
Step 17
Turn the key switch to "UPPER CONTROL."
Step 18
Get on the platform. When getting on or
off the platform, use three-point support
(for example, 2 arms and 1 leg, or 1 arm
and 2 legs).
Step 19
Select the lift/travel select switch to
either "LIFT" or "TRAVEL," operate each
joystick and switch on the upper control
panel. Make sure each function operates
normally, and does not make strange
noises.
Step 20
(1) Select the lift/travel select switch to "LIFT."
(2) Hold the switch more than 0.3 second and
then release it, the power indicator light
goes on and the alarm buzzer sounds.
(3) Raise and lower the platform completely
a few times, and make sure the platform
operates smoothly (no strange noises,
vibrations, or rattling).
(4) The platform lowering will stop when
the platform is 1.4 m (SV06CNL) / 1.6 m
(SV08CNL) above the ground. To lower
the platform fully, check that there are no
people and/or objects under the platform,
release the lift/travel joystick controller
once, wait 2 seconds and then operate
again to lower the platform fully.
Step 21
(1) Select the lift/travel select switch to
"TRAVEL."
(2) Hold the switch more than 0.3 second and
then release it, the power indicator light
goes on and the alarm buzzer sounds.
(3) Operate the lift/travel joystick controller
slightly and slowly to "FORWARD"
and "BACKWARD." Make sure the
machine travels forward and backward
correspondingly.
(4) Return the lift/travel joystick controller to
neutral. Make sure the machine stops.
Step 22
Travel a few meters, and make sure the
machine operates smoothly (no strange
noises, vibrations, or rattling). Repeat a
few times.
Step 23
Steer and make sure the steering is
smooth (no strange noises, vibrations, or
rattling).
Step 24
(1) Push the emergency stop button.
(2) Attempt to raise and lower the platform,
to travel forward and backward, and to
steer left and right. Make sure that these
operations are disabled.
(3) Pull the emergency stop button up to
release the stop state.
Natural lowering check 227
Step 25
Raise the platform to its highest, and leave
it there for a few minutes. Then try to raise
the platform more. Make sure it does not
raise at all (or go down naturally).
Tilt warning check 228
Step 26
(1) Lower and retract the platform fully.
(2) Remove the upper control panel from the
guardrails of the platform.
(3) Place a piece of wood 40 mm thick under
both wheels on one side.
(4) Travel the machine up onto these pieces
from the ground with the upper control
panel.
(5) Make sure that the tilt light goes on and
the alarm buzzer sounds.
(6) Attempt to raise the platform. Make sure
the raise function is disabled.