
G-25
Z-106164_EN ● 00
P
roduct
I
nstallatIon
P
roduct
I
nstallatIon
Unpacking the Product
The TMU is delivered on a wooden pallet and is se-
cured to the pallet with four screws.
The appliance is protected by a wooden packaging
lined with rubber protection at the contact surfaces.
Once the appliance is in the boiler room or close
to the installation location (refer to the
“Handling”
section below for information on transport):
1.
Unscrew the wooden packaging and careful-
ly remove all the packaging pieces.
2.
Discard packaging according to applicable
local regulations.
3.
Using a wrench with an hex head size 8,
remove four screws (See
)
from the
bottom of the appliance and the pallet.
To prevent component damage during
storage due to moisture, bags of desic-
cant are placed inside the TMU. Make
sure to remove them before operating
the appliance.
Handling the Product
î
This appliance is heavy and re-
quires sufficient workforce to
move and handle it, as well as
an appropriate means of trans-
port. Make sure to comply
with applicable local stand-
ards and regulations on prod-
uct handling.
î
It is prohibited to handle the appliance
using protruding components or rest the
appliance on protruding components.
î
Failure to comply with these recom-
mendations can result in damage to the
appliance or injuries to the personnel
Using a forklift truck or another appropriate means,
move the appliance in its packaging close to the
installation location.
î
To lift the appliance from the front,
make sure that the front bottom
panel is removed.
î
Do not insert the forklift arms under the
appliance if the condensate trap and
front bottom panel are installed.
i
î
Failure to comply with these recom-
mendations can result in damage to
the TMU or injuries to the personnel.
1.
Remove bottom panel from the appliance,
refer to
“Opening and Closing the Front
Door and Access Panels” on page G-26.
2.
Slide the arms of the fork lift underneath the
appliance, from the front of the appliance
).
3.
Move the appliance carefully to its final po
-
sition. Make sure to comply with the recom-
mended clearances. See
Fig. 12. Appliance Transport and Installation
4 screws to be re-
moved from the bot-
tom of the appliance
(left and right side) to
remove the appliance
from the pallet.
i
X4
Содержание TMU 500
