12
STEP 19: (SEE FIGURE 18)
• Hook the rear of the clutch/idler assembly onto the
two shoulder bolts assembled to the outside of the
tractor frame. Lift the front of the assembly and attach
it to the R.H. and L.H. hanger brackets using two pivot
lock pins and 1/8" hairpin cotters.
FIGURE 18
VIEWED FROM LEFT SIDE
FIGURE 19
VIEWED FROM UNDERNEATH
FIGURE 17
STEP 18: (SEE FIGURE 17)
• Turn the clutch/idler assembly right side up.
• Slightly loosen the hex bolt next to the flat idler pulley.
Install the drive belt down between the hex bolt and the
flat idler pulley with the flat side of the belt against the
pulley. Retighten the hex bolt.
• Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
STOP
Did you choose the correct drive belt for
your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
DRIVE BELT
FLAT IDLER
PULLEY
HEX BOLTS
PIVOT LOCK PIN
(use second hole)
SHOULDER
BOLT
1/8" HAIRPIN
COTTER
L.H. HANGER
BRACKET
1/8"
HAIRPIN
COTTER
ENGINE
PULLEY
HEX BOLTS
FLAT IDLER
PULLEY
TENSIONING
CHAIN
LEFT SIDE
OF TRACTOR
STEP 20: (SEE FIGURE 19)
• Assemble the drive belt onto the engine pulley. You
may need to remove the belt from the large pulley on
the clutch/idler assembly in order to assemble it onto
the engine pulley. When re-assembling the belt onto
the large pulley, be sure the belt is between the large
pulley and the hex bolt next to it.
• Place tension on the belt by pulling the left side
tensioning chain out as far as the 3/32" hairpin cotter
that was installed in the chain in step 15 will allow.
Secure the chain in this position by inserting a 1/8"
hairpin cotter through the chain.
NOTE;
To prevent the chain from dragging on the
ground, loop the end of the chain though the pivot lock
pin. Refer to figure 56 on page 23.
•
Go to step 48 on page 21.
Содержание LST42E
Страница 29: ...29 NOTES...
