Agri-Fab LST42E, Руководство пользователя

Страница: 17 / 36

17
FIGURE 36
STEP 35: (SEE FIGURE 35)
• Assemble the cable bracket to inner part of the double
holes in the clutch/idler assembly using two 5/16"
x 3/4" carriage bolts and 5/16" nylock nuts. If your
tractor has a 42" mower deck, use the two front holes
in the cable bracket. If your tractor has a 46" mower
deck, use the two rear holes.
STEP 36: (SEE FIGURE 36)
• Attach the two rear pulley frame brackets to the inside of
the clutch/idler assembly using two 5/16" x 1" hex bolts,
eight 5/16" washers and two 5/16" nylock nuts for each
bracket.
• Attach the two front pulley frame brackets to the inside
of the clutch/idler assembly using two 5/16" x 3/4" hex
bolts, 5/16" washers and 5/16" nylock nuts for each
bracket. Add extra washers if needed in step 39.
• Insert a tensioning chain through the hole shown and
attach the end link to the spring on the lower idler arm.
FIGURE 35
CABLE OPERATED MANUAL ATTACHMENT CLUTCH
FIGURE 37
HEX BOLTS
DRIVE BELT
FLAT IDLER
PULLEY
(#46989)
STEP 37: (SEE FIGURE 37)
• Two different length drive belts are included with
your snow thrower. Tractors with manual attachment
clutches and dual front deck suspension brackets use
the 55" drive belt with
#46989 printed on the outside
of the belt. DO NOT USE the other belt.
• Slightly loosen the hex bolt next to the flat idler pulley.
Install the drive belt down between the hex bolt and the
flat idler pulley with the flat side of the belt against the
pulley. Retighten the hex bolt.
• Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
STOP
Did you choose the correct drive belt for
your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
CABLE
BRACKET
5/16" x 3/4"
CARRIAGE BOLT
5/16" NYLOCK
NUT
42"
DECKS
46"
DECKS
TENSIONING CHAIN
(lower idler arm)
5/16" x 3/4" HEX BOLT
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
5/16"
WASHER
(4) 5/16" WASHERS