Agri-Fab LST42E, Руководство пользователя

Страница: 13 / 36

13
STEP 22: (SEE FIGURE 21)
• Fasten the R.H. Side Plate (bend facing out) to the
front three holes shown in the tractor frame using
three 3/8" x 1" thread forming bolts, three 3/8" lock
washers and one 1/2" washer. Place the washer on
the third bolt as a shim between the side plate and
the frame. Tighten all bolts. Repeat for the L.H. side.
NOTE:
If you installed a bolt in the fourth hole in step 21,
assemble a 5/16" flange nut onto the bolt after the side
plate is installed.
•
Go to step 25 on this page.
(3) 3/8" x 1"
THREAD FORMING
BOLTS
5/16" FLANGED
NUT
(SEE NOTE)
(3) 3/8" LOCK
WASHERS
1/2" WASHER
5/16" x 1"
CARRIAGE BOLT
(SEE NOTE)
FIGURE 21 RIGHT SIDE VIEW
FRONT SUSPENSION
BRACKET
REMOVE BOLTS
IF PRESENT
FIGURE 22 RIGHT SIDE VIEW
STEP 23: (SEE FIGURE 22)
• Remove any bolts found in the holes shown.
STEP 21: (SEE FIGURE 20)
• Remove bolts from front three holes shown.
• If a bolt is present in the fourth hole, replace it with
a 5/16" x 1" carriage bolt without a nut. The bracket
fastened to inside of frame must remain in place.
FRONT
SUSPENSION
BRACKET
REPLACE BOLT
(IF PRESENT)
REMOVE BOLTS
(IF PRESENT)
FIGURE 20 RIGHT SIDE VIEW
INSTRUCTIONS FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSION BRACKETS
FASTEN SIDE PLATES TO TRACTOR
I
f your tractor resembles figure 20, start with step 21.
If your tractor resembles figure 22, start with step 23.
STEP 25: (SEE FIGURE 24)
• Install a hex head shoulder bolt, a 3/8" washer and a
3/8" flanged lock nut in the R.H. and L.H. Side Plates.
FIGURE 24 RIGHT SIDE VIEW
3/8" WASHER
SHOULDER
BOLT
3/8" FLANGED
NUT
STEP 24: (SEE FIGURE 23)
• Fasten the R.H. Side Plate (bend facing out) to the
three holes shown in the tractor frame. Use three 3/8"
x 1" thread forming bolts, 3/8" lock washers and 1/2"
washers. Use the 1/2" washers as shims between the
Side Plate and the tractor frame. Tighten all bolts and
repeat for the L.H. side.
NOTE: If the bolt inserts freely into the front hole, assemble
a 3/8" flanged nut onto the bolt.
(3) 3/8" x 1"
THREAD FORMING
BOLTS
(3) 3/8" LOCK
WASHERS
3/8" FLANGED NUT
(SEE NOTE)
(3) 1/2" WASHERS
FIGURE 23 RIGHT SIDE VIEW