Agri-Fab LST42E, Руководство пользователя

Страница: 15 / 36

15
INSTALLING CLUTCH/IDLER ASSEMBLY
This section covers the installation of the Clutch/Idler
assembly to tractors with attachment clutches that are
either rod operated (p. 15), cable operated (p. 17) or
electric (p. 19). Use the appropriate instructions for your
tractor.
ROD OPERATED MANUAL ATTACHMENT CLUTCH
STEP 29: (SEE FIGURE 29)
• Move the attachment clutch lever on the dash panel to
the disengaged (down) position.
• Screw the trunnion onto the end of the snow thrower
engagement rod.
• Locate the clutch arm (where the mower clutch rod
was connected) underneath the right hand side the
tractor, just to the inside of the suspension arm.
If
there is an extension
attached to the clutch lever, the
extension, bolt and nut must be removed and stored
with the mower deck.
IMPORTANT: Re-attach the extension
to the clutch
lever before reinstalling the mower deck.
• Position the engagement rod to the inside of the
clutch arm and insert the drilled end of the rod
through the arm. Secure with a 5/64" hairpin cotter.
FIGURE 29 RIGHT SIDE VIEW
ENGAGEMENT ROD
5/64" HAIRPIN
COTTER
TRACTOR'S CLUTCH ARM
SUSPENSION ARM
TRUNNION
REMOVE EXTENSION,
BOLT AND NUT
(IF PRESENT)
STEP 30: (SEE FIGURE 30)
• Attach the two rear pulley frame brackets to the inside
of the clutch/idler assembly using two 5/16" x 1" hex
bolts, eight 5/16" washers and two 5/16" nylock nuts
for each bracket.
• Attach the two front pulley frame brackets to the inside
of the clutch/idler assembly using two 5/16" x 3/4" hex
bolts, 5/16" washers and 5/16" nylock nuts for each
bracket. Add extra washers if needed.
FIGURE 30
FIGURE 31
STOP
Did you choose the correct drive belt for
your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
STEP 31: (SEE FIGURE 31)
• Two different length drive belts are included with
your snow thrower. Tractors with manual attachment
clutches and dual front deck suspension brackets use
the 55" drive belt with
#46989
printed on the outside
of the belt.
DO NOT USE
the other belt.
• Slightly loosen the hex bolt next to the flat idler pulley.
Install the drive belt down between the hex bolt and the
flat idler pulley with the flat side of the belt against the
pulley. Retighten the hex bolt.
• Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
TENSIONING CHAIN
(lower idler arm)
5/16" x 3/4" HEX BOLT
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
5/16"
WASHER
(4) 5/16" WASHERS
#46989
DRIVE BELT
FLAT IDLER
PULLEY
HEX BOLTS
• Insert a tensioning chain through the hole shown and
attach the end link to the spring on the lower idler arm.