Agri-Fab LST42E, Руководство пользователя

Страница: 18 / 36

18
FIGURE 40 VIEWED FROM UNDERNEATH
FIGURE 39
STEP 40: (SEE FIGURE 40)
• Assemble the short "V" belt onto the engine pulley
and then onto the large pulley on top of the clutch/idler
assembly. The belt must be placed to the inside of the
engine pulley keeper, the idler pulley and the keeper
bolt located beside the large pulley.
IMPORTANT: Do Not assemble the "V" belt around the
outside of the engine pulley keeper or the keeper bolt.
• Go to step 48 on page 21.
STEP 39: (SEE FIGURE 39)
• Remove the engine pulley keeper from the side of
the tractor frame by removing the washer and nut
that secure the keeper. Attach the new pulley keeper
supplied with the snow thrower, reusing the original
bolt, washer and nut.
NOTE:
Some tractors may already be equipped with a
pulley keeper that is identical to the new one supplied.
• Attach the clutch/idler assembly to the tractor frame
as follows. Hook the rear of the assembly onto the two
shoulder bolts you installed on the tractor frame. Lift
the front of the assembly and attach it to the hanger
brackets you installed using two pivot lock pins and
1/8" hairpin cotters.
FIGURE 38
STEP 38: (SEE FIGURE 38)
• Move the attachment clutch lever on the dash panel to
the disengaged (down) position.
• Place the clutch/idler assembly on the floor on the right
side of the tractor.
• Attach the tractor's clutch cable to the cable bracket.
Secure the cable housing guide (groove down) to the
cable bracket using the original collar and a 5/64" hair
cotter pin.
• Place a spacer on the welded pin on the idler arm.
Hook the end of the clutch spring over the pin and
secure it with a 1/4" washer and a 5/64" hair cotter pin.
5/64" HAIR
COTTER PIN
1/4" WASHER
TRACTOR'S
CLUTCH CABLE
5/64" HAIR
COTTER PIN
SPACER
NEW ENGINE PULLEY KEEPER WITH
ORIGINAL BOLT, NUT AND WASHER
PIVOT LOCK PIN
(use second hole)
1/8" HAIRPIN COTTER
ENGINE
PULLEY
KEEPER BOLT
IDLER
PULLEY
ENGINE
PULLEY
KEEPER
Left Side
of Tractor