2.1.8 SAFE OPERATION OF THE POWER
TAKE-OFF
The person using the machine should have knowledge and experience on
how the tractor's power take-off works.
The machine should only be attached to the tractor with the shaft
connection supplied or recommended by the manufacturer.
Make sure that there is plastic protection on the shaft.
Make sure that the shaft is correctly attached to the tractor's power take-off.
Machine's sharp turns while shaft is moving can cause serious
damage on the shaft.
Please note that being around the shaft with loose clothes can pose a
serious danger.
Never touch the moving shaft.
When using vertical auger feed mixer and tractor power take-off, do not
exceed the power take-off speed of 540 rpm. Do not overload the power
take-off and machine, and do not engage the clutch suddenly. Before starting
to operate the power take-off, make sure that the PTO rotation direction is
correct.
Chains that prevent the shaft cover from turning while the shaft is in
operation must be fixed to a stationary element of the machine.
There are marks on the body of the power take-off that indicate which
end of the shaft should be attached to the tractor, please pay attention to
those marks.
Detach the drive shaft each time when it is not necessary to drive the machine
or when the tractor and feed mixer are at an angle which is not appropriate for
both.
Do not use damaged power take-off, this may cause accidents. A damaged
shaft must be repaired or replaced.
2.1 INFORMATION and WARNING LABELS
Safety and warning labels used in vertical auger feed mixers are described in the
table given below. The user should take care that the information and warning
labels of the machine are legible throughout the period of use of the machine.
When you want to replace worn or damaged safety labels, you can request new
labels using the codes provided in the label table of AGL Industries TWISTER VT
user manual. You should not expose safety labels to chemicals that will damage
them.
20
Содержание Twister VT Series
