AGL Twister VT Series, Руководство пользователя

Страница: 18 / 52

Except for the technical service, welding etc. operations on the machine can
only be carried out by persons with appropriate authorizations and
qualifications, but interventions not carried out by the technical service
cause the product to be excluded from the scope of warranty.
Machine hydraulic installation should be checked regularly. There should
be no leakage in the fittings such as nipples etc.
Before starting repairs in hydraulic and pneumatic systems, reduce the air
pressure for hydraulic, for oil and pneuma
ic 0 a d c le el e e
the flammables from the system.
The points that need to be lubricated regularly on the machine are shown
by means of labels, check the lubrication status regularly.
Since the errors in the drawbar can cause serious problems in motion,
replace the drawbar with a new one if it is deformed.
If your feed mixer has brakes, make sure that the brakes are working
properly, otherwise, contact technical service immediately and do not use
the machine again without intervening in the error.
In the event of injuries due to pressurized hydraulic oil, apply to the
nearest hospital immediately.
Direct contact of compressed air with your skin causes serious
injuries.
It is strictly forbidden to be on the vehicle's observation ladder while the
machine is moving, as this will cause serious injuries.
The reducer and oil tank oil level of vertical auger feed mixers should be
checked regularly.
The condition of the blades of the augers in vertical auger feed mixers
should be checked regularly. In case of deformation, you can order new
blades with the blade codes specified in the identification of the machine
chapter.
In the case of replacement of machine's auger blades, make sure that the
engine of the tractor is off, the tractor's contact key is removed and the
shaft is not attached to the tractor's power take-off.
Machine can be cleaned without entering the reservoir. Cleaning can be
done by means of a cleaning brush on the observation platform.
It is not recommended to be in the machine's reservoir for cleaning.
Since the materials such as straw etc. are flammable, it is very dangerous
to be around the machine with flammable materials or cigarettes during the
operation of the machine.
18